Bottom Wood

Parquet board can be laid in two ways: either 'floating' method or by gluing the boards to the ground. 'Floating' way faster and more economical, but not the most convenient for further use. This method of installation means that the bond between a hardwood boards are held on the floor due to skirting boards and nothing more. When you go to 'Floating' floor in the room hear the rustle of a light, so now it is accepted between the concrete base and wooden flooring to lay a special insulating substrate. However, the soundproofing material will not save position when it comes the need to polish the floor. Make cost-effective and high quality grind on the 'floating' floor is almost impossible. Much more reliably stick to the bottom of floorboard.

It can be attached to the dsp, plywood, concrete or old wood floors, most importantly, that the base was fixed and the height difference does not exceed 2 mm by 2 meters. Classic parquet. Parquet most expensive type of flooring, but it and most popular. Appreciate the parquet for his longevity. Solid wood, which is used for the production of parquet, easy to repair. It can not just grind, but also repeatedly tsiklevat, ie remove the worn top layer and re-varnish. After this procedure, the old parquet floor looks like new. Quality, however, and the cost of flooring depends on a number of indicators, especially on the type of wood. Good flooring should be made of solid wood with minimal linear extension.

Comments are closed.

Proudly powered by WordPress
Theme: Esquire by Matthew Buchanan.

© 2012-2024 Profit Pacific All Rights Reserved